Removal Procedure

Up/Down or In/Out Adjustment

1. Open the rear door.
Fig 1: Door Side Hinge Bolts Sequence (Rear Door)
Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to PAINT DAMAGE NOTICE .
2. Apply masking tape to the fender and the door edges.

   Loosen the door side hinge bolts in the specified sequence (1, 2, 3, 4). Do not remove the bolts from the door.

3. Adjust the door up or down by repositioning the door as needed.
4. Adjust the door in or out by repositioning the door as needed.

Fore/Aft Adjustment

Fig 1: Hinge Pillar Side Bolts Sequence (Rear Door)
Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to PAINT DAMAGE NOTICE .
1. Apply masking tape to the fender and door edges.

   Loosen the hinge pillar side bolts in the specified sequence (1, 2, 3, 4). Do not remove the bolts from the door.

2. Adjust the door fore and aft by repositioning the door as needed.