LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement >> Installation Procedure

Installation Procedure

    IMPORTANT: The engine mounts must NOT bend or deflect from the vertical position, damage to the mount will occur.
  1. Install the transmission mount to the vehicle.
    2. Fig 1: Identifying Transmission Mount Bolts
    GM1559378Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the transmission mount retaining bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb. ft).

  3. Install the transmission support. Refer to Transmission Support Replacement .
  4. Remove the jack and block of wood.
  5. Install the exhaust system.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals