LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Shift Control Assembly To Tunnel Reinforcement Retaining Nuts
    GM1954230Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control assembly (1) to the tunnel reinforcement.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nuts (2) securing the shift control assembly to the tunnel reinforcement.

    Tighten:  Tighten the nuts to 12 N.m (106 lb. in).

    3. Fig 2: Identifying Shift Control Assembly Electrical Connector
    GM1954220Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector (1) to the shift control assembly.
  4. Install the center console assembly. Refer to Front Floor Console Replacement .
  5. Install the shift control trim plate by inserting the front retaining tabs to the console. Press down on the rear of the trim plate to engage the rear retaining tabs.
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    7. Fig 3: Identifying Shift Control Linkage Rod
    GM1954218Courtesy of GENERAL MOTORS CORP.
  7. Connect the shift control linkage rod to the shift control assembly.
  8. Install the shift control linkage adjustment nut finger tight.
  9. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals