LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Control Valve Body Accumulator Assembly Installation

Control Valve Body Accumulator Assembly Installation

    Fig 1: Locating Overdrive Clutch & Center Support Fluid Passage Sleeve
    GM801804Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW overdrive clutch fluid passage sleeve (39) into the case.
  2. Install the NEW center support fluid passage sleeve (38) into the case.
    3. Fig 2: View Of Control Valve Body Accumulator Assembly
    GM802258Courtesy of GENERAL MOTORS CORP.
  3. Install the control valve body accumulator assembly (47) onto the case.
  4. Install the detent lever spring (52) onto the case.
  5. Install the control valve body retaining bolts (53) into the case and hand tighten.
    6. Fig 3: Identifying Control Valve Body Accumulator Assembly Bolts
    GM802259Courtesy of GENERAL MOTORS CORP.
  6. Install the control valve body accumulator assembly bolts (49, 51) into the case and hand tighten.
    7. Fig 4: Control Valve Body Assembly Bolt Tightening Sequence
    GM802251Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  7. Tighten the control valve body accumulator retaining bolts in sequence.

    Tighten:  Tighten the control valve body accumulator bolts to 11 N.m (8 lb. ft).

    8. Fig 5: Installing Spacer Between Manual Shaft Detent Lever & Detent Assembly
    GM816745Courtesy of GENERAL MOTORS CORP.
  8. Install a 0.8 mm spacer (1) between the shift shaft detent lever (600) and the shift shaft detent assembly (52).
  9. Tighten the detent assembly bolts (53).

    Tighten:  Tighten the control valve body bolts (53) to 11 N.m (8 lb. ft).

  10. Remove the spacer (1).
scientia non olet · About LEMON Manuals