LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gages >> Repair Instructions >> Speedometer Adapter Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the battery negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel (I/P) outer trim cover Refer to Instrument Panel Outer Trim Cover Replacement .
  3. Remove the knee bolster. Refer to Knee Bolster Replacement .
  4. Remove the instrument panel extension. Refer to Instrument Panel Extension Replacement .
    5. Fig 1: Identifying Vehicle Speed Interface Module (VSIM) Electrical Connector & Main Wiring Harness Connector
    GM2017830Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Using a suitable tool, remove the cable ties (1) from the from the I/P lower support brace (2).
    IMPORTANT: Cable ties are a single use item.
  5. Detach the vehicle speed interface module (VSIM) wiring harness (3).
  6. Disconnect the vehicle speed interface module (VSIM) electrical connector (5) from the main wiring harness connector (4).
    7. Fig 2: Identifying Vehicle Speed Interface Module (VSIM) & Lower Fascia Support
    GM2017831Courtesy of GENERAL MOTORS CORP.
  7. Remove the vehicle speed interface module (VSIM) (1) from the I/P beam and the lower fascia support (2).
    8. Fig 3: Identifying Vehicle Speed Interface Module (VSIM) Electrical Connectors & Steering Wheel Angle Sensor
    GM2017832Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the vehicle speed interface module (VSIM) (2) electrical connectors (3) from the steering wheel angle sensor (1).
  9. Remove the vehicle speed interface module (VSIM) (2) from the vehicle.
scientia non olet · About LEMON Manuals