LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gages >> Diagnostic Information and Procedures >> Engine Oil Pressure Indicator Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the engine oil pressure (EOP) sensor.
  2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal 1 and ground.
    • If greater than the specified range, test the circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 2 and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Verify the scan tool Engine Oil Pressure Sensor parameter is less than 0.2 volt.
    • If greater than the specified range, test the signal circuit terminal 3 for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Install a 3A fused jumper wire between the signal circuit terminal 3 and the 5-volt reference circuit terminal 2. Verify the scan tool Engine Oil Pressure Sensor parameter is greater than 4.8 volts.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  6. Ignition ON, perform the IPC displays test with the scan tool and verify the EOP indicator turns OFF when commanded.
    • If the EOP indicator does not turn OFF, replace the IPC.
  7. If all circuits test normal, test or replace the EOP sensor.
scientia non olet · About LEMON Manuals