LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G5 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Mechanical - 2.0L) >> Repair Instructions - Off Vehicle >> Engine Front Cover and Oil Pump Installation

Engine Front Cover and Oil Pump Installation

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Front Cover
    GM1825083Courtesy of GENERAL MOTORS CORP.
  1. Install two new friction washers.
  2. Install the engine front cover with a new gasket.
    3. Fig 2: View Of Engine Front Cover Bolts
    GM1769934Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: The center bolt (1) should be tightened last.
  3. Install the engine front cover bolts.

    Tighten:  Tighten the engine front cover bolts to 25 N.m (18 lb ft).

  4. Install the long water pump bolt.

    Tighten:  Tighten the water pump bolt to 25 N.m (18 lb ft).

    5. Fig 3: View Of Drive Belt Tensioner
    GM412154Courtesy of GENERAL MOTORS CORP.
  5. Install the accessory drive belt tensioner.
  6. Install the accessory drive belt tensioner bolt.

    Tighten:  Tighten the bolt to 45 N.m (33 lb ft).

scientia non olet · About LEMON Manuals