LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G5 Base, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Shift Control Mechanism
    GM1663966Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control (3) to the vehicle.
  2. Connect the shift lock solenoid harness connector (4).
    3. NOTE: Refer to Fastener Notice .
  3. Install the shift control nuts (2).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    4. Fig 2: View Of Shift Control
    GM851244Courtesy of GENERAL MOTORS CORP.
  4. Connect the shift cable to the shift control assembly.
  5. If the shift control knob was removed, install the shift control knob. Refer to Floor Shift Control Knob Replacement .
  6. Install the console trim plate. Refer to Console Front Trim Plate Replacement .
scientia non olet · About LEMON Manuals