LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Vibe Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Latch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Hood Latch And Release Cable
    GM239165Courtesy of GENERAL MOTORS CORP.
  1. Install the hood latch release cable (1) to the hood latch (2).
    2. Fig 2: Hood Latch Bolts
    GM239366Courtesy of GENERAL MOTORS CORP.
  2. Install the hood latch (1) to the vehicle. Secure the latch with the 3 bolts (3) and one plastic retainer but do not tighten fully.
    3. NOTE: Refer to Fastener Notice .
  3. Make the following adjustments to the hood latch:
    • The striker shaft lines up with the center groove of the latch.
    • The hood is flush with the front fender. Refer to Hood Adjustment .

      Tighten:  Tighten the hood latch bolts to 8 N.m (70 lb in).

  4. Lower the hood.
scientia non olet · About LEMON Manuals