LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Vibe Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Remove/Install Hood Hinge
    GM239365Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: When replacing the hood hinge, apply anti-corrosion treatment to the hinge and the body mating surface, and to the hinge and the hood mating surface. Refer to Anti-Corrosion Treatment and Repair .
  1. Install the hood hinge (1) to the vehicle, aligning the mating marks. Secure the hinge with the 2 mounting bolts.

    Tighten:  Tighten the hinge bolts to 20 N.m (15 lb ft).

  2. Install the left front fender, if removed. Refer to Front Fender Replacement - Left Side .
  3. Install the right front fender, if removed. Refer to Front Fender Replacement - Right Side .
  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  5. Install the hood. Refer to Hood Replacement .
scientia non olet · About LEMON Manuals