LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Vibe Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front Fender Replacement - Right Side >> Removal Procedure

Removal Procedure

    Fig 1: Body Panel
    GM431898Courtesy of GENERAL MOTORS CORP.
    NOTE: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
  1. Raise and support the hood.
  2. Remove the right fender flare. Refer to Front Fender Flare Replacement .
  3. Remove the right wheelhouse panel (1). Refer to Wheelhouse Panel Replacement .
  4. Remove the front fascia. Refer to Front Bumper Fascia Replacement .
  5. Remove the right rocker molding. Refer to Rocker Panel Molding Replacement (Accessory Molding) or Rocker Panel Molding Replacement (Production Molding) .
  6. Remove the right head lamp assembly. Refer to Headlamp Assembly or Headlamp Bulb Replacement .
  7. Remove hood assist rod. Refer to Hood Hold-Open Rod Replacement .
  8. Remove right rear inner fender splash guard.
    9. Fig 2: Remove/Install Front Fender
    GM239358Courtesy of GENERAL MOTORS CORP.
  9. Remove the right front fender (1) to rocker panel bolt.
    10. Fig 3: Front Fender Door Jam Bolts
    GM239359Courtesy of GENERAL MOTORS CORP.
  10. Remove the 2 right front fender to door jamb (3) bolts.
    11. Fig 4: Top Front Fender bolts
    GM828397Courtesy of GENERAL MOTORS CORP.
  11. Remove the top 2 right front fender bolts (1).
    12. Fig 5: Left Front Fender Bolt
    GM828404Courtesy of GENERAL MOTORS CORP.
  12. Remove the 1 bolt (2) from the front of the right front fender.
  13. Remove the right front fender (1) from the vehicle.
scientia non olet · About LEMON Manuals