LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Vibe Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front Fender Replacement - Right Side >> Installation Procedure

Installation Procedure

    Fig 1: Left Front Fender Bolt
    GM828404Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the front fender (1) to the vehicle. Secure the fender with the 1 bolt (2).

    Tighten:  Tighten the front fender bolt to 20 N.m (15 lb ft).

    2. Fig 2: Top Front Fender bolts
    GM828397Courtesy of GENERAL MOTORS CORP.
  2. Install the top 2 front fender (1) bolts.

    Tighten:  Tighten the top front fender bolts to 20 N.m (15 lb ft).

    3. Fig 3: Front Fender Door Jam Bolts
    GM239359Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 door jamb (3) to front fender bolts.

    Tighten:  Tighten the door jamb to front fender bolts to 20 N.m (15 lb ft).

    4. Fig 4: Remove/Install Front Fender
    GM239358Courtesy of GENERAL MOTORS CORP.
  4. Install the front fender (1) to rocker panel bolt.

    Tighten:  Tighten the front fender to rocker panel bolt to 20 N.m (15 lb ft).

  5. Install right fender rear inner splash guard.
  6. Install hood assist rod. Refer to Hood Hold-Open Rod Replacement .
  7. Install right headlamp assembly. Refer to Headlamp Assembly or Headlamp Bulb Replacement .
  8. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .
  9. Install the right rocker panel molding. Refer to Rocker Panel Molding Replacement (Accessory Molding) or Rocker Panel Molding Replacement (Production Molding) .
  10. Install the right wheel house panel. Refer to Wheelhouse Panel Replacement .
  11. Install the right fender flare. Refer to Front Fender Flare Replacement .
  12. Close hood panel.
scientia non olet · About LEMON Manuals