Engine Oil Pressure Indicator Inoperative

Step	Action	Yes	No
1	Did you review the Instrument Cluster Description and Operation and perform the necessary inspections?	Go to Step 2	Go to Symptoms - Instrument Panel, Gages and Console
2	Verify that the oil gage indicator is inoperative. Does the oil gage indicator operate normally?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Disconnect the oil pressure switch connector. Connect fused jumper from the oil pressure switch connector to chassis ground. Does the oil pressure indicator illuminate?	Go to Step 4	Go to Step 5
4	Replace the oil pressure switch. Did you complete the repair?	Go to Step 8	-
5	With oil pressure switch connector still grounded, test the oil pressure signal circuit at cavity 10 of the instrument panel cluster assembly for continuity to ground. Refer to Circuit Testing . Is ground present?	Go to Step 7	Go to Step 6
6	Repair the open in the oil pressure signal circuit between cavity 10 of the instrument panel cluster assembly and the oil pressure switch. Refer to Wiring Repairs . Did you complete the repair?	Go to Step 8	-
7	Replace the instrument panel cluster. Refer to Instrument Cluster Replacement . Did you complete the repair?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3