Door Ajar Indicator Malfunction

Step	Action	Yes	No
Schematic Reference: Door Lock/Indicator Schematics Connector End View Reference: Vehicle Access Connector End Views
1	Did you review the Power Door system Description and Operation?	Go to Step 2	Go to Power Door Locks Description and Operation
2	Disable the dome lamp override switch. Is the dome lamp or the door ajar indicator always on?	Go to Dome Lamps Always On	Go to Step 3
3	Open each door individually while observing the dome lamps. Does the dome lamp illuminate with each door?	Go to Step 4	Go to Dome Lamps Inoperative
4	Access the instrument panel cluster (IPC) connector. With the doors closed, back probe the door ajar indicator control circuit with a test lamp that is connected to a good ground. Does the test lamp illuminate?	Go to Step 5	Go to Step 6
5	Inspect for poor connections at the IPC connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 10	Go to Step 9
6	Test for a short to ground in the door ajar indicator control circuit between the multifunction alarm module and the IPC. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 10	Go to Step 7
7	Inspect for poor connections at the multifunction alarm module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 10	Go to Step 8
8	Replace the multifunction alarm module. Refer to Multifunction Alarm Module Replacement . Did you complete the replacement?	Go to Step 10	-
9	Replace the IPC. Refer to Instrument Cluster Replacement . Did you complete the replacement?	Go to Step 10	-
10	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2