Circuit/System Testing

Rear Hatch Ajar Switch Circuit Testing

1. Ignition OFF, disconnect the harness connector at the rear hatch ajar switch.
2. Test for less than 1 ohm of resistance between the ground circuit and ground.
   • If greater than 1 ohm, test the ground circuit for an open/high resistance.
3. Verify the scan tool liftgate ajar switch parameter is low.
   • If not low, test the signal circuit for a short to ground. If the circuit tests normal, replace the BCM.
   • If the rear hatch indicator is still ON, test the IPC rear hatch indicator signal circuit for a short to voltage. If the circuit tests normal, replace the IPC
4. Install a 3-amp fused jumper wire between the signal circuit and ground. Verify the scan tool door ajar parameter is high.
   • If not high, test the signal circuit of the door ajar switch for a short to voltage or an open/high resistance. If circuit tests normal, replace the BCM.
5. If all circuits test normal, test or replace the liftgate ajar switch.