LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls & Fuel - 2.4L - DTC P0010 To P0354) >> DTC P0107 or P0108 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: You must perform the circuit/system testing, in order to verify the integrity of the MAP sensor circuits, before proceeding with the component testing.
  1. Turn ON the ignition, with the engine OFF, and remove the MAP sensor.
  2. Install a 3-amp fused jumper wire between the 5-volt reference circuit terminal C and the corresponding terminal of the MAP sensor.
  3. Install a jumper wire between the low reference circuit terminal A of the MAP sensor and ground.
  4. Install a jumper wire at terminal B of the MAP sensor.
  5. Connect a DMM between the jumper wire from terminal B of the MAP sensor and ground.
  6. Install the J 35555  to the MAP sensor vacuum port. Slowly apply vacuum to the sensor while observing the voltage on the DMM. The voltage should vary between 0-5.2 volts, without any spikes or dropouts.
    • If the voltage is not within the specified range or is erratic, replace the MAP sensor.
scientia non olet · About LEMON Manuals