LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Intake Manifold Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold
    GM1571773Courtesy of GENERAL MOTORS CORP.
  1. Install the intake manifold gasket, if necessary.
  2. Install the intake manifold.
    NOTE: Refer to Fastener Notice .
  3. Install the intake manifold bolts and nuts.

    Tighten:  Tighten the bolts and nuts to 10 N.m (89 lb in).

    4. Fig 2: Engine Harness Electrical Connector
    GM1590505Courtesy of GENERAL MOTORS CORP.
  4. Position the engine harness.
  5. Install the knock sensor connector clip to the oil level indicator tube.
  6. Connect the engine harness electrical connector (3) to the knock sensor harness.
    7. Fig 3: Engine Harness Clip
    GM1590535Courtesy of GENERAL MOTORS CORP.
  7. Install the engine harness clip (4) to the intake manifold.
    8. Fig 4: A/C Refrigerant Pressure Sensor Electrical Connector
    GM1590533Courtesy of GENERAL MOTORS CORP.
  8. Connect the A/C refrigerant pressure sensor electrical connector.
    9. Fig 5: Air Bleed Hose
    GM1590504Courtesy of GENERAL MOTORS CORP.
  9. Position and install the air bleed hose (2) to the engine.
  10. Position the radiator surge tank air bleed hose clamp at the engine (1).
    11. Fig 6: Engine Harness Clip To Surge Tank Air Bleed Hose
    GM1590557Courtesy of GENERAL MOTORS CORP.
  11. Install the engine harness clip to the surge tank air bleed hose.
    12. Fig 7: Windshield Wiper Motor Electrical Connector
    GM1590536Courtesy of GENERAL MOTORS CORP.
  12. Connect the windshield wiper motor electrical connector.
  13. Install the engine harness clip to the wiper motor.
    14. Fig 8: Fuel Injector Inline Electrical Connector
    GM1590626Courtesy of GENERAL MOTORS CORP.
  14. Connect the electronic throttle actuator electrical connector (3).
  15. Connect the engine harness electrical connector (1) to the fuel injector electrical connector.
  16. Install the oil level indicator tube bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    17. Fig 9: Brake Booster Vacuum Hose
    GM1590611Courtesy of GENERAL MOTORS CORP.
  17. Install the brake booster hose to the intake manifold.
  18. Position the brake booster vacuum hose clamp at the intake manifold.
    19. Fig 10: EVAP Canister Purge Solenoid Valve Tube
    GM1571757Courtesy of GENERAL MOTORS CORP.
  19. Install the EVAP canister purge solenoid valve tube. Refer to Plastic Collar Quick Connect Fitting Service .
  20. Install the fuel rail. Refer to Fuel Rail Assembly Replacement .
  21. Install the throttle body. Refer to Throttle Body Assembly Replacement .
  22. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals