LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold Cover
    GM1694523Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the intake manifold cover studs.
    3. Fig 2: Camshaft Position Actuator Solenoid Valve Electrical Connector
    GM1591651Courtesy of GENERAL MOTORS CORP.
  3. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  4. Reposition the positive crankcase ventilation (PCV) hose clamp.
  5. Remove the PCV hose from the cover.
  6. Disconnect the intake (1) and exhaust (2) camshaft position actuator solenoid valve electrical connectors.
    7. Fig 3: Engine Harness Clip
    GM1591657Courtesy of GENERAL MOTORS CORP.
  7. Remove the engine harness clip (1) from the cam cover.
    8. Fig 4: Engine Harness Bracket
    GM1591665Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine harness bracket (1) from the intake manifold cover stud.
    9. Fig 5: EVAP Canister Purge Solenoid Valve Electrical Connector
    GM1591661Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the evaporative emission (EVAP) canister purge solenoid valve electrical connector (1).
  10. Remove the engine harness clip (2) from the EVAP purge solenoid bracket.
  11. Remove the engine harness clips (3, 4) from the cam cover.
  12. Remove the ignition coils. Refer to Ignition Coil Replacement .
    13. Fig 6: Camshaft Cover
    GM1578306Courtesy of GENERAL MOTORS CORP.
  13. Remove the camshaft cover bolts.
  14. Remove the camshaft cover.
scientia non olet · About LEMON Manuals