LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Removal

Intake Manifold Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Emission Canister Valve Tube
    GM825004Courtesy of GENERAL MOTORS CORP.
    NOTE: Never attempt to remove the intake manifold from a hot engine, allow the engine to cool to ambient temperature. The intake manifold is made of a composite plastic and can be damaged if it is removed when the engine is hot.
  1. Remove the evaporative emission (EVAP) canister valve tube (1).
  2. Remove the EVAP canister valve (2).
    3. Fig 2: Throttle Body
    GM1594326Courtesy of GENERAL MOTORS CORP.
  3. Remove the throttle body bolts.
  4. Remove the throttle body.
    5. Fig 3: Fuel Rail Assembly
    GM1594328Courtesy of GENERAL MOTORS CORP.
  5. Remove fuel pipes and clips.
  6. Remove the fuel rail bolts.
  7. Remove the fuel rail.
    8. Fig 4: View Of Fuel Injector Tip Insulators
    GM1336272Courtesy of GENERAL MOTORS CORP.
  8. Remove the fuel injector tip insulators and discard.
    9. Fig 5: Intake Manifold
    GM1403970Courtesy of GENERAL MOTORS CORP.
  9. Remove the intake manifold retaining nuts and bolts.
  10. Remove the intake manifold.
  11. Remove the intake manifold gasket, if necessary. The gasket can be used again if it is not damaged.
scientia non olet · About LEMON Manuals