LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Installation

Cylinder Head Installation

WARNING: This page is about a different variant/trim than selected.
Tools Required

J 45059  Angle Meter

    Fig 1: View Of Cylinder Head, Bolts & Gasket
    GM1403908Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use any sealing material.
  1. Install the cylinder head gasket to the block.
  2. Install the cylinder head.
    3. Fig 2: Identifying Cylinder Head Bolt Tightening Sequence
    GM412510Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Always use new cylinder head bolts.
    NOTE: Refer to Fastener Notice .
  3. Install and tighten the cylinder head bolts in sequence.

    Tighten: 

    • Tighten the bolts to 30 N.m (22 lb ft).
    • Tighten the bolts an additional 155 degrees in sequence. Use the J 45059  .

    4. Fig 3: Locating Front Cylinder Head Bolts
    GM412425Courtesy of GENERAL MOTORS CORP.
  4. Install the front cylinder head bolts.

    Tighten:  Tighten the cylinder head bolts to 35 N.m (26 lb ft).

scientia non olet · About LEMON Manuals