LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls & Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: EVAP Canister Purge Valve Electrical Connector
    GM1591661Courtesy of GENERAL MOTORS CORP.
  1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  2. Disconnect the evaporative emission (EVAP) canister purge valve electrical connector (1).
    3. Fig 2: EVAP Canister Purge Valve Tube
    GM1571757Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP canister purge valve tube. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Disconnect the chassis EVAP vapor line from the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: EVAP Canister Purge Valve
    GM1578478Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP canister purge valve bracket bolt.
  6. Remove the EVAP canister purge valve with bracket.
  7. Remove the EVAP canister purge valve from the bracket.
  8. Inspect for carbon release in the EVAP canister purge valve ports. If there is any loose carbon, replace the EVAP canister and any components necessary to remove the carbon particles.
scientia non olet · About LEMON Manuals