LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls & Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: EVAP Canister Purge Valve
    GM1578478Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve to the bracket.
  2. Position the EVAP canister purge valve with bracket to the cylinder head.
    NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister purge valve bracket bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    4. Fig 2: EVAP Canister Purge Valve Tube
    GM1571757Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve tube. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: EVAP Canister Purge Valve Electrical Connector
    GM1591661Courtesy of GENERAL MOTORS CORP.
  6. Connect the EVAP canister purge valve electrical connector (1).
  7. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals