LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls & Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: ECT Sensor
    GM1713085Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the ECT.

    Tighten:  Tighten the sensor to 20 N.m (15 lb ft).

    2. Fig 2: ECT Sensor Electrical Connector
    GM1591858Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (6) to the ECT sensor.
  3. Fill the cooling system as needed. Refer to Draining and Filling Cooling System (GE-47716) or Draining and Filling Cooling System (2.4L LE5 Only) .
scientia non olet · About LEMON Manuals