LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls & Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CKP sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor.
    NOTE: Refer to Fastener Notice .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the sensor bolt to 10 N.m (89 lb in).

    4. Fig 2: CKP Sensor Electrical Connector
    GM1589842Courtesy of GENERAL MOTORS CORP.
  4. Connect the CKP sensor electrical connector (1).
  5. Install the starter. Refer to Starter Motor Replacement .
scientia non olet · About LEMON Manuals