LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls & Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: CMP Actuator Solenoid Valve
    GM1578482Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Lubricate the solenoid valve O-ring seals with clean engine oil.
  2. Install the intake (2) CMP actuator solenoid valve and bolt, as required.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Install the exhaust (1) CMP actuator solenoid valve and bolt, as required.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Camshaft Position Actuator Solenoid Valve Electrical Connector
    GM1591651Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake (1) or exhaust (2) camshaft position actuator solenoid valve electrical connector, as required.
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals