LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls & Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: APP Sensor
    GM1593853Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the APP sensor nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

    3. Fig 2: APP Sensor Electrical Connector
    GM1593852Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector.
  4. Confirm that the APP sensor connector locking clip is fully secured.
  5. Verify the operation of the accelerator pedal.
  6. Install the knee bolster. Refer to Knee Bolster Replacement .
scientia non olet · About LEMON Manuals