Rear Compartment Lid Replacement

Fig 1: Rear Compartment Lid

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disconnect the rear compartment lid buttress latch release cable and pull it through the lid and set it aside with the pass-through grommet. Refer to Rear Compartment Lid Buttress Latch Release Cable Replacement . Disconnect the antenna cable from the decklid and pull it through the lid and set it aside with the grommet assembly. Refer to Digital Radio Antenna Cable Replacement .
1	Rear Compartment Lid Bolts (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 25 N.m (19 lb ft)
2	Rear Compartment Lid Tip: Transfer any parts over to the new lid if needed.

Callout

Component Name

Preliminary Procedures

Disconnect the rear compartment lid buttress latch release cable and pull it through the lid and set it aside with the pass-through grommet. Refer to Rear Compartment Lid Buttress Latch Release Cable Replacement .
Disconnect the antenna cable from the decklid and pull it through the lid and set it aside with the grommet assembly. Refer to Digital Radio Antenna Cable Replacement .

Rear Compartment Lid Bolts (Qty: 4)

NOTE: Refer to Fastener Notice .

Tighten: 25 N.m (19 lb ft)

Rear Compartment Lid
Tip: Transfer any parts over to the new lid if needed.