Rear License Lamp Replacement
Rear License Lamp Replacement
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications . |
|
| 1 | Screws, Rear License Plate Lamp Assembly (Qty: 2) Tighten: 2 N.m (18 lb in) |
| 2 | Lamp Assembly, Rear License Plate Tip: Push one side of the lamp assembly inside the rear bumper cover hole and pull downward to disconnect the electrical connector. |
| 3 | Connector, Rear License Plate Electrical Tip: Twist the socket counterclockwise in order to remove from the lamp housing. |
| 4 | Bulb, Rear License Plate |