Washer Solvent Container Replacement

Fig 1: Washer Solvent Container

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Base) or Front Wheelhouse Liner Replacement (Turbo) . Drain the washer solvent into a suitable clean container.
1	Windshield Washer Pump Hose Assembly Tip: Disconnect the hose at the hinge pillar and air inlet panel. Disengage the integral washer hose clip from the electronic control module (ECM) bracket.
2	Windshield Washer Solvent Container Screws (Qty: 3) Tighten: 10 N.m (89 lb in)
3	Windshield Washer Container Assembly Tip: Lower the windshield washer container from behind the left front fender area.
4	Windshield Washer Container Pump Kit Tip: Disconnect the washer hose at the pump and use two flat-bladed tools and pry the washer pump from the container.