LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> Fuel Gage Inaccurate or Inoperative >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the fuel level sensor connector, install a signal generator and instrument panel tester between the signal circuit and the low reference circuit.
  2. Ignition ON, vary the resistance on the signal generator from 40-250 ohms. With the scan tool verify that the Fuel Tank Level Remaining parameter displays the correct fuel level percent. Refer to Fuel Level Specifications .
    • If the fuel level percent is incorrect, test the signal circuit and the low reference circuit for an open/high resistance. If all circuit tests normal, replace the ECM.
  3. Ignition ON, vary the resistance on the signal generator from 40-250 ohms. Observe the fuel gage and verify that the fuel gage displays the correct fuel level. Refer to Fuel Level Specifications .
    • If the fuel gage display is incorrect, test or replace the fuel gage.
  4. If all circuits test normal, test or replace the fuel level sensor.
scientia non olet · About LEMON Manuals