Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Review the vacuum schematics in the Boost Control System Description. Refer to Boost Control System Description .
- Ignition OFF, visually and physically inspect the supercharger components for any of the following conditions:
Inspect the vacuum lines for:
- Cracking
- Loose fit
- Improper connections
- Improper routing
- Inspect the following components for damage, and for proper connections, adjustments, and installation:
- The bypass valve actuator
- The boost control solenoid
- The bypass valve lever
- The bypass valve cable. Refer to.
- Engine running, command the supercharger bypass (SCB) solenoid from 0-90 percent with a scan tool. Observe the operation of the bypass valve. It should move as the DC percentages are varied.
- Verify there are no vacuum leaks at the supercharger manifold gaskets and supercharger intake plenum.