Rotating the Engine for Service Access
WARNING: This page is about a different variant/trim than selected.
- Tools Required
-
J 41131 Engine Tilt Strap. See Special Tools
- Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement in Engine Controls - 3.8L.
- Apply the parking brake.
- Put the transaxle in the Neutral position.
- Remove the engine mount struts. Refer to Engine Mount Strut Replacement - Right Side and Engine Mount Strut Replacement - Left Side .
- Install the J 41131 (2) to the engine mount strut bracket (1) and the upper radiator support (3). See Special Tools .
- Rotate the engine forward for component access.