LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. If replacing the drive belt tensioner, lubricate the thermostat bypass upper and lower pipe assembly seals with engine coolant and install the upper and lower pipe assemblies.
  2. Fig 1: View Of Drive Belt Tensioner
    GM326960Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt tensioner.
  4. NOTE: Refer to Fastener Notice .
  5. Install the drive belt tensioner bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Install the heater hose adapters with the heater hoses to the drive belt tensioner. Refer to Heater Inlet Hose Replacement (L26, L32) or Heater Inlet Hose Replacement (RPO LS4) and to Heater Hose Replacement - Outlet (L26, L32) or Heater Hose Replacement - Outlet (RPO LS4) in Heating Ventilation and Air Conditioning.
  7. Install the generator. Refer to Generator Replacement (RPO LS4) or Generator Replacement (RPOs L26/L32) in Engine Electrical.
  8. Install the drive belt. Refer to Drive Belt Replacement (L26)  or Drive Belt Replacement (L32) .
  9. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (RPO LS4) or Coolant Recovery Reservoir Replacement (RPOs L26, L32) in Engine Cooling.
  10. Fill the cooling system. Refer to Draining and Filling Cooling System (L26, L32 GE 47716 Fill) or Draining and Filling Cooling System (L26, L32 Static Fill) or Draining and Filling Cooling System (LS4 GE 47716 Fill) or Draining and Filling Cooling System (LS4 Static Fill) in Engine Cooling.
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) or Battery Negative Cable Disconnection and Connection (RPOs L26/L32) in Engine Electrical.