Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the EVAP vent valve to the bracket (2).
- Install the vent hose (4) to the EVAP vent valve.
- Install the EVAP vent valve and the bracket.
- Install the EVAP vent valve bracket bolt (3).
Tighten: Tighten the bolt to 10 N.m (89 lb in).
- Connect the EVAP vent valve electrical connector (1).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.