LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls & Fuel - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Throttle Body Assembly (L26)
    GM911046Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP purge valve (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP purge valve bolt (2).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in)

  3. Connect the EVAP canister purge valve electrical connector.
    4. Fig 2: Female Connector & Fuel Rail Pipe
    GM910914Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve purge pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals