LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Grand Prix GXP >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls & Fuel - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (RPO LS4) or Coolant Recovery Reservoir Replacement (RPOs L26, L32) in Engine Cooling.
  2. Remove the drive belt. Refer to Drive Belt Replacement (L26) or Drive Belt Replacement (L32) in Engine Mechanical - 3.8L.
    3. Fig 1: Disconnecting/Reconnecting Electrical Connector To CMP Sensor
    GM389047Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector (2) from the camshaft position sensor (1).
    4. Fig 2: Removing/Installing Camshaft Position (CMP) Sensor
    GM12305Courtesy of GENERAL MOTORS CORP.
  4. Remove the camshaft position sensor bolt.
  5. Remove the camshaft position sensor from the engine front cover.
scientia non olet · About LEMON Manuals