Inflatable Restraint Passenger Presence System Replacement - Front

Fig 1: Passenger Presence System

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. CAUTION: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction. CAUTION: Refer to SIR Caution . Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the recliner handle. Refer to Seat Back Recliner Handle Replacement - Front . Remove the power seat switch. Refer to Seat Switch Replacement - Power . Remove the seat cushion outer trim panel. Refer to Front Seat Trim Panel Replacement . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
1	Seat Cushion Cover Refer to Front Seat Cushion Cover Replacement . Tip: Remove the seat cushion cover and pad as an assembly.
2	Inflatable Restraint Passenger Presence Sensor Retainer (Qty: 2)
3	Inflatable Restraint Passenger Presence System Sensor Tip: Note the routing of the wiring harness and connector location for installation. Disconnect the electrical connector.
4	Front Seat Adjuster Assembly Refer to Front Seat Adjuster Replacement (Two-Way Manual) or Front Seat Adjuster Replacement (Six-Way Power) .
5	Inflatable Restraint Front Passenger Presence Module Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 3 N.m (25 lb in)
6	Inflatable Restraint Front Passenger Presence Module Refer to Control Module References for programming and setup information. Tip: Disconnect the electrical connector.