LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Grand Prix Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Repair Instructions >> Instrument Cluster Head Up Display Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of HUD Electrical Connector
    GM1200054Courtesy of GENERAL MOTORS CORP.
  1. Connect the HUD electrical connector. Lower the HUD into the I/P opening.
    2. Fig 2: View Of HUD Bolts
    GM1198037Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Start the HUD bolts by hand to avoid cross threading. Install the HUD bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 3: View Of HUD Screw
    GM1198005Courtesy of GENERAL MOTORS CORP.
  3. Install the HUD screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  4. If a new HUD was installed remove the protective plastic sheet from the glass.
  5. Install the I/P upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement .
  6. Install the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
  7. Install the instrument cluster. Refer to Instrument Cluster Replacement .
  8. Install the I/P cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .
  9. Install the I/P steering column opening filler. Refer to Steering Column Opening Filler Replacement .
  10. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
scientia non olet · About LEMON Manuals