Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the electronic compass module.
- Ignition OFF, test for less than 1.0 ohm of resistance between the compass module ground and ground.
- If greater than 1.0 ohm, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates when connected between the electronic compass module ignition 1 voltage circuit and ground.
- If the test lamp does not illuminate, test the ignition 1 voltage circuit for an open/high resistance.
- Test for less than 1 ohm of resistance in the compass clock signal circuit and the compass data signal circuit.
- If greater than 1 ohm of resistance, test the compass clock signal circuit and the compass data signal circuit for an open/high resistance. If the circuit(s) test normal, replace the driver information center (DIC).
- If all circuits test normal, test or replace the electronic compass module.