Turn Signal Multifunction Switch Replacement

Turn Signal Multifunction Switch Replacement

Removal Procedure





Caution: Refer to SIR Caution.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement.
3. Disconnect the electrical connectors.
4. Release the multifunction switch clips from the stalk switch mount, remove the multifunction switch.

Installation Procedure




1. Install the multifunction switch to the stalk switch mount.
2. Connect the electrical connectors.
3. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.