LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> G6 L4-2.4L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Drive Belt Tensioner >> Service and Repair

Drive Belt Tensioner: Service and Repair



Drive Belt Tensioner Replacement

Tools Required

J 45025Torque Wrench Adapter

Removal Procedure




1. Remove the drive belt.
2. Remove the drive belt tensioner bolt.
3. Remove the drive belt tensioner.

Installation Procedure




1. Position the drive belt tensioner. Ensure that the tensioner is flush with the front cover.

Notice: Refer to Fastener Notice .

Important: In order to obtain the proper torque when using any torque wrench adapter you must use the following formula: Pre-set Torque = Torque Wrench Length x Torque Desired divided by Torque Wrench Length + Extension Length.

2. Install the drive belt tensioner bolt.
Using the J 45025 tighten the drive belt tensioner bolt.

Tighten the bolt to 45 N.m (33 lb ft).

3. Install the drive belt.


scientia non olet · About LEMON Manuals