Parking Brake Warning Switch: Service and Repair

Park Brake Warning Lamp Switch Replacement

Removal Procedure




1. Remove the floor console.
2. Disconnect the electrical connector (1) from the park brake warning lamp switch.
3. Remove the park brake warning lamp switch screw (2).
4. Remove the park brake warning lamp switch.

Installation Procedure




1. Install the park brake warning lamp switch to the park brake lever assembly.

Notice: Refer to Fastener Notice .

2. Install the park brake warning lamp switch screw (2).

Tighten the screw to 3 N.m (27 lb in).

3. Connect the electrical connector (1) to the park brake warning lamp switch.
4. Install the floor console.
5. Check the operation of the park brake warning lamp switch.