Headlamp Replacement

Fig 1: Headlamp Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Headlamp Assembly Bolts (Qty: 4) Tip: Remove the inner upper grille fascia push-pin. Pull the lamp forward until the lamp disengages from the lower bracket. Push the lower inside corner of the headlamp inboard until the outer lens releases from under the outer fender flange. Rock the headlamp composite side to side and pull outward. Disconnect the electrical connector. Tighten: 10 N.m (89 lb in)
2	Headlamp Assembly Tip: Disconnect the headlamp bulb electrical connectors.
3	Headlamp J-Nuts

Callout

Component Name

Front Headlamp Assembly Bolts (Qty: 4)
Tip:

Remove the inner upper grille fascia push-pin.
Pull the lamp forward until the lamp disengages from the lower bracket.
Push the lower inside corner of the headlamp inboard until the outer lens releases from under the outer fender flange.
Rock the headlamp composite side to side and pull outward.
Disconnect the electrical connector.

Tighten: 10 N.m (89 lb in)

Headlamp Assembly
Tip: Disconnect the headlamp bulb electrical connectors.

Headlamp J-Nuts