Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

If DTC P0441 is the only EVAP DTC set, the most likely cause is an inoperable EVAP canister purge valve. Inspect the EVAP canister purge valve carefully for faulty connections and erratic operation.
The information included in the Freeze Frame data can be useful in determining vehicle operating conditions when the DTC was first set. If the Freeze Frame data indicates the engine was not running when the diagnostic ran and failed, the fault is probably a leak in the EVAP system. Refer to DTC P0455 .
A faulty EVAP canister can cause a DTC P0441 and P0455 to set. The EVAP canister fault may be temperature sensitive. Test the EVAP canister when the canister temperature is similar to the temperature when the diagnostic failed. Refer to Evaporative Emission (EVAP) Control System Diagnosis .
An intermittent malfunction may be caused by a fault in any of the EVAP solenoid electrical circuits. Inspect the wiring harness and components for an intermittent condition. Refer to Intermittent Conditions .