LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System - 1.8L (LNK) - Troubleshooting & Diagnosis) >> Malfunction Indicator Lamp (MIL) Inoperative >> Test Description

Test Description

WARNING: This page is about a different variant/trim than selected.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step checks whether there is communication between the PCM and a scan tool device. If the PCM is unable to provide serial data to the scan tool, there will be no MIL control.
  2. 3:  If other instrument panel cluster (IPC) functions are not working correctly check for an open GAUGE fuse or for a lack of power and ground to the IPC.
  3. 4:  This step checks for an open MIL control circuit or for an internal PCM failure.
  4. 5:  An open fuse determines if a voltage is constantly being applied to the control circuit.
Malfunction Indicator Lamp (MIL) Inoperative

Step Action Yes No
Schematic Reference:  Engine Controls Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC information
2 
  1. Connect a scan tool.
  2. Turn ON the ignition, with the engine OFF.
Does the scan tool display any engine data?		 Go to Step 3  Go to Scan Tool Does Not Communicate with Keyword Data Line in Computer/Integrating Systems
3  Observe the instrument panel cluster (IPC) assembly operation.
Do all other functions of the IPC function normally?		 Go to Step 4  Go to Diagnostic Starting Point - Instrument Panel, Gages and Console in Instrument Panel, Gages and Console
4 
  1. Turn OFF the ignition.
  2. Disconnect powertrain control module (PCM) electrical connector with the malfunction indicator lamp (MIL) control circuit.
  3. Turn ON the ignition, with the engine OFF.
  4. Probe the MIL control circuit on the harness side with a 3-amp fuse jumper wire to ground.
Does the MIL illuminate?		 Go to Step 9  Go to Step 5 
5  Did the fuse in the jumper wire open? Go to Step 6  Go to Step 7 
6 Repair the short to voltage in MIL control circuit. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?		 Go to Step 10  -
7
  1. Turn ON the ignition, with the engine OFF.
  2. Backprobe the MIL control circuit at the IPC assembly with a 3-amp fuse jumper wire to ground.
Does the MIL illuminate?		 Go to Step 8  Go to Diagnostic Starting Point - Instrument Panel, Gages and Console in Instrument Panel, Gages and Console
8 Repair the open in the MIL control circuit. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?		 Go to Step 10  -
9 Replace the PCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 10  -
10 Turn ON the ignition, with the engine OFF.
Is the MIL illuminated?		 Go to Step 11  Go to Step 2 
11
  1. Use the scan tool in order to clear the DTCs.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Observe the MIL operation.
Is the MIL illuminated?		 Go to Diagnostic System Check - Vehicle in Vehicle DTC Information System OK
scientia non olet · About LEMON Manuals