LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.
    Fig 1: Inlet Air Duct, TP Sensor, Fasteners
    GM229615Courtesy of GENERAL MOTORS CORP.
  1. Remove the inlet air duct from between the air cleaner and throttle body.
  2. Remove the 2 fasteners (3) from the throttle position (TP) sensor (2).
  3. Remove the TP sensor (2) from the throttle body.
scientia non olet · About LEMON Manuals