LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Air Injection (AIR) Shut-Off Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: AIR Shut-Off Valve Components
    GM1287602Courtesy of GENERAL MOTORS CORP.
  1. Install the AIR shut-off valve (3) and gasket (4) to the bracket and pipe assembly (5).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the 3 parts with the 2 bolts.

    Tighten:  Tighten the 2 fasteners to 8 N.m (71 lb in).

    3. Fig 2: AIR Shut-Off Valve, Outlet Hose, Inlet Hose And Fasteners
    GM1287603Courtesy of GENERAL MOTORS CORP.
  3. Install the AIR shut-off valve and bracket to the engine.
  4. Secure the AIR shut-off valve (3) with the 2 bolts (1).

    Tighten:  Tighten the 2 fasteners to 21 N.m (16 lb ft).

  5. Connect the air inlet hose (2) to the AIR shut-off valve (3).
  6. Connect the air outlet hose (4) to the AIR shut-off valve.
  7. Install the AIR pressure sensor. Refer to Secondary AIR Injection Pressure Sensor Replacement .
scientia non olet · About LEMON Manuals