LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Secondary AIR Injection Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: AIR Pump Components
    GM1287599Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the AIR pump assembly to the vehicle and secure with 3 fasteners (1, 2, 7).

    Tighten:  Tighten the 3 fasteners to 7 N.m (62 lb in).

  2. Connect the AIR pump discharge hose (6).
  3. Connect the AIR pump relay electrical connector (4).
  4. Connect the AIR pump electrical connector (5).
  5. Connect the electrical ground strap (3).

    Tighten:  Tighten the ground strap fastener to 7 N.m (62 lb in).

    6. Fig 2: Secondary Air Injection Pump
    GM1287600Courtesy of GENERAL MOTORS CORP.
  6. Swing the stone shield (1) up and secure with the retaining pin.
  7. Install the 2 bolts that secure the stone shield (1).

    Tighten:  Tighten the 2 shield bolts to 10 N.m (89 lb in).

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals