LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Secondary AIR Injection Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Electrical Connector, Air Pressure Sensor And Shut Off Valve
    GM1467195Courtesy of GENERAL MOTORS CORP.
  1. Install the AIR pressure sensor (2) to the shut-off valve (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the AIR pressure sensor with 2 fasteners.

    Tighten:  Tighten the 2 fasteners to 5 N.m (44 lb in).

  3. Connect the electrical connector (1) to the AIR pressure sensor (2).
scientia non olet · About LEMON Manuals