LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 1.8L (LNK) - Introduction (2 Of 2)) >> Repair Instructions >> Rocker Arm Oil Control Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Rocker Arm Oil Control Solenoid Valve And O-Ring Removed
    GM828864Courtesy of GENERAL MOTORS CORP.
  1. Install a new O-ring (2) and the rocker arm oil control solenoid valve (1) into the cylinder head.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Secure the rocker arm oil control solenoid valve with the one fastener.

    Tighten:  Tighten the fastener to 9 N.m (80 lb in).

  3. Connect the electrical connector to the solenoid valve.
    4. Fig 2: PCV Hose, Breather Hose, EVAP Hose
    GM850214Courtesy of GENERAL MOTORS CORP.
  4. Connect the PCV hose (1) and the PCV breather hose (2) to the engine.
  5. Connect the EVAP hoses.
    6. Fig 3: View Of Engine Upper Cover
    GM828878Courtesy of GENERAL MOTORS CORP.
  6. Install the engine cover (1) to the engine.
  7. Secure the engine cover (1) with the four fasteners.

    Tighten:  Tighten the fasteners to 7 N.m (62 lb in).

scientia non olet · About LEMON Manuals